First step, After coonecting the AC adaptor to the DC-IN jack(port NO.6) in the WISEGIGA, connect the power cable.

Second step, After connecting the LAN cable to the WAN connector(port No.1) in the Xdsl/Cable Modem, connect the other end to the WISEGIGA WAN cable.

Third step, After connecting the LAN cable to the LAN connector(port No.2~5) in the WISEGIGA, connect the other end to the computer's LAN connector.

Then you can check light of the Power and Ready LED. Also you can see to flash the internet connection error LED. But the Error LED is atomatically off when the internet connection is properly connected.
If you are under occasions, you have to check your computers set-up information before you install WISEGIGA.
1. When installing on shared router or at the lower end of wireless AP;
2. When fixed IP is used for WISEGIGA Internet connection setup.
Information prior to network setup is required to use WISEGIGA.
From the start button, click Run and in the open window enter cmd (command-win98 user).
Then click OK.
Enter the ipconfig/all into the window.
After confirming the IP address and Default Gateway, make a note of them.
The confirmed Default Gateway is needed for port forwarding or DMZ setup in the shared router if WISEGIGA is installed at the lower end of the router. The IP address is used for connection with the router.